THICKNESSING PLANER Mod.SP1 - mm.520.
Working width mm. 520
High removal capacity.
Electric lifting of the working table.
It’s possible to work at the same time pieces of various thickness.
High efficacy in 4-speed draft (photograph). Thanks to roll adjustable pressure, different feed speed and particular helical scoring of enter roll, the draft is efficient with each kind of wood and even with high removal.
Stiffness of working table (photograph). The working table is supported by 4 screws (large diameter) that give an high stability in each working condition. The lifting constructive concept allows to maintain perfectly the position of the table without using the clamping.
Working of pieces of various thickness (photograph). On demand, it’s available a draft solution to allow the contemporaneous working of pieces of various thickness, made by a particular steel roll (sectionized) instead of the standard one.
The working table (photograph) can be equipped – on demand – with idle rolls to optimize feed and productivity.

• Technical features:
  
• working width 520 mm
  
• working height (min./max.) 3/250 mm
  
• worktable dimensions 580x1000 mm
  
• max. stock removal 8 mm
  
• cutterblock speed 4500 rpm
  
• cutterblock diameter/no. of knives 120/4
  
• no. 4 feed speeds of workpiece 5-8-12-18 m/min
  
• diameter of dust extraction outlet 150 mm
  
• motor power 5,5 kw 7,5 hp 50 hz
  
• net weight basic machine 650 kg
  
• overall dimensions basic machine :
  H= mm 1110 L= mm 1050 W= mm 750
  
• Standard equipment:
  
• ribbed-cast iron worktable with vertical sliding by means of 4 steel screws
  
• front roller in helicoidal steel
  
• rear rubber-coated steel roller
  
• powered table lifting with 2 speeds and micrometric sliding
  
• numerical readout of working height with decimal control of the quota
  
• emergency pushbotton on rear machine side
  
• padlockable main switch
  
• soundproof infeed and outfeed barrier
• manual star-delta-start
  
• overload switch protection
  
• auxiliary low voltage circuit (110 volt)
  
• automatic brake on motor
  
• exhaust hood
  
• knife-setting device
  
• service kit for use and maintenance

• Worktable with 2 idle rollers
  
• 1st powered sectioned steel feed roller in alternative to the helicoidal roller
  
• "TERSA" cutterblock with throwaway knives complete with one set of knives